Lifting the film is simple — use a fingernail or tweezers or even lay a strip of tape on top to help pull it up. Video of the Day It can be difficult to pull off the plastic. It's designed to withstand the rigors of shipping and delivery, after all. It depends what type of film it is ? If its a glued film , warm gently with a hair dryer and crape with a plastic scaper then clean with a mild solvant cleaner, if it is a water adhered film gently use a plastic scraper with warm soapy water t remove and then clean with mild solvant cleaner, once film is removed use glass cleaner to finish to job. Gather into a pouch and strip off the film completely. Then carefully pull the masking film from the corners toward the middle of the sheet, forming a kind of pouch with the film. This has the advantage that dirt and dust remain on the film for the most part and so do not soil the material. Finally, pull the film off the sheet completely. Additionally, use eye protection. Not just safety goggles, but ‘sealed’ eye protection as these nasty chemicals are absorbed through your eyes. A full-face mask is another option instead of a separate mask and goggles. But, having said all of that, the heat stretchable UV protective film seems like the winner to me. Use enough pressure to break through the plastic, but not dig and scratch the glass. Working with a sharp, fresh blade helps. Peel the film slowly from top to bottom. If it is starting to stick and rip, use the scraper to loosen the bond as you slowly pull. An extra person may be helpful here. You will need a heat gun, a microfiber towel, plastic scraper and adhesive remover. Wrap the microfiber tightly around the scraper so it has a sharp point, then soak the towel in adhesive remover. Next heat the film till its very soft and start jabbing at the edge of the film till the plastic and adhesive rolls up over itself. Procedure: Use a hot air gun or hair blower to heat up the film and soften it, taking care to avoid overheating the film or the frame. Carefully use a scraping knife to lift the edges of the film and peel it off. A residue of the film adhesive may remain on the frame after the film is removed. Caution: Do not apply excessive heat to the film or Cover the areas surrounding the plastic -- either the housing for the cells or the lid of a light with a built-in solar panel -- with painter's tape before applying the chosen clear-coat material. Peel the tape away once the coating dries. Advertisement. Clean the plastic covering the solar cells with soapy water to see if the plastic clears up. Then, while continuing to gently heat the adhesive, you can take off the larger sections. Once you have all the film removed, you can clean the adhesive with adhesive remover. Once you have UB0mX.

how to remove old protective film from plastic